Before I could take the engine out of the car, there were still a few more things I had to do. First I had to take off the other transmission strut. Next I had to disconnect the transmission from the engine block. I also had to disconnect the torque converter from the transmission. Finally we were ready to get the engine out using an engine hoist. After we had the engine out, I had to remove some parts from the old engine so that we can reuse them on the new engine. I took off the flywheel, both of the exhaust manifolds, the belt pulley, the motor mounts, and the distributor cap. I also removed the spark plugs, but we will not reuse those. After I had removed those parts, I replaced the torque converter back onto the transmission. I am looking forward to continuing to make progress on the car.
0 Comments
Leave a Reply. |
Author
This is a journal for me to write about my Senior Project. Archives
April 2017
Categories |